Champion Juicer - Juicer Heavy Duty Commercial Model Almond
The Champion Juicer is manufactured by Plastaket Manufacturing Co., located in the heart of California and began producing the Champion Juicers in 1955. A family owned business that is still strong today.
The Champion Juicer is the answer to every juicing problem. Because it operates on the mastication process, the Champion Juicer chews the fibers and breaks up the cells of vegetables and fruits. This give you more fiber, enzymes, vitamins and trace minerals. This all results in the darker, richer color of the juice and a sweeter, richer more full-bodied flavor.
G5-PG710, Heavy duty front and rear ball bearing installation for smoother running, maximum R.P.M.'S. Added winding capacity which increases starting torque and allows the motor to run cooler increasing the durability factor and performance under heavy use conditions. Variable 110/220 volt 50/60 hertz with stainless steel shaft for longer wear. Can be converted for domestic or overseas use.
Champion Juicers come in four available colors:
For use around the home, see Champion's Household Juicers:
Turn your Champion Juicer into a wheat grinder or grain mill with this versatile attachment.
FREQUENTLY ASKED QUESTIONS
Q: My juicer worked fine the first time but now when I plug it in it doesn't turn on?
A: The newer model Champion Juicers have a sensor located on the juicing parts that will not allow the unit to operate unless all parts are properly positioned (refer to trouble-shooting section of the owner's manual).
Q: My juicer produces warm juice even though I juice as slowly as possible. Why?
A: Warm juice can only be created by operating the unit to slowly. The Champion requires a constant introduction of new material. (Average juice time to make 1qt. = 6 min)
Q: Why does my juicer make a loud clicking noise when I feed vegetables into it?
A:The clicking sound is created by the motor's centrifugal switch. 1st possibility is feeding the unit to aggressively. 2nd possibility could be a dull cutter.
Q: What is the best way to keep my juicer looking new?
A: Good clean up is important. Soaking the parts overnight in a strong solution of dish soap. If stains are extreme add bleach to the solution, then rinse thoroughly.
Q: Is it safe to put my juicers parts in the dishwasher?
A: NO, these parts are not dishwasher safe. The parts are made from stainless steel and then laminated with nylon. These two materials heat and cool differently and would eventually cause a problem.
Q: What's the difference between the regular screen and the optional large hole screen?
A: It's just like it sounds. The regular screen has holes that are smaller to allow less pulp into the juice. The large hole screen allows a much greater amount of pulp to enter juice. (Approximately 50% more pulp. This will vary depending on material).
Q: Will the grain mill attachment work on my older Champion Juicer?
A: The optional grain mill will work on all Champions produced over the years. Some small size modifications are required for customers having extremely old juicers.
Q: How often should I replace my cutter?
A: The cutter wear is based on usage. Customers using the Champion only occasionally may get 10-15 years of service. With heavy use the cutters need replacement every 18-24 months. If you have concerns our customer service people can assist you.
For all repair and defect issues pertaining to Champion Juicer's 10 Year Limited Warranty, please see our Suggested Use tab.