Setup:

1. Wash Skin
   Wash skin with soap & water or oil-free toner. Dry well.
2. Heat Product
   Microwave: Remove cap & seal. Place ball upright in centre of microwaveable dish along with desired roller. Heat on high for 10 sec. DO NOT OVERHEAT. CONTAINER MAY MELT & CAUSE BURNS. Attach roller firmly to ball.
   Hot water: Remove cap & roller. Place sealed ball 2/3 way in hot water for 5 min.
   
   Caution: product will spoil if seal immerses in water. Remove & dry. Remove plug seal & attach desired roller firmly.
3. After Heating
   Put cap on & place Roll-On upside down. Wait 20 sec before use. Keep Roll-On upside down during treatment to keep product flowing. Before application, check product flow by rolling it onto a strip. Roll-On is ready once it rolls easily & is coated with product.

Directions:

1. Roll on product
   Roll SLOWLY in direction of hair growth, leaving a paper-thin layer of product.
2. Apply Strip
   Immediately smooth down strip over product leaving end of strip extended beyond product. Rub strip to adhere well.
3. Zip-Off Immediately
   Hold skin taut below strip with one hand. Use other hand to grasp lower end of strip and zip-off quickly in opposite direction of hair growth, keeping strip/hand as close & parallel to the skin as possible.
   TIP: the faster the strip is removed, the better the result.
4. Repeat
   Hint: The same strip can be used several times. With experience, you can cover larger areas with product and remove with one strip in quick, successive motions.

CleanUp & After Care

• After use, wash skin with cool water to soothe skin. Pat dry.
• Remove roller after use. Wash with warm water & dry.
• Replace plug seal after use and store product in a warm, DRY place. Water & humidity cause ineffectiveness.
• Strips may be washed & reused. Extra Parissa Applicator Strips sold separately
• High skin sensitivity may occur after fi rst use, but decreases with ensuing use as hair weakens.
• Skin often turns pink & spotty after hair removal, but should disappear in a few hours. If irritation persists, discontinue use.
• Regrowth varies per person, appearing anywhere from 2-6 weeks.
• Try Parissa Azulene Oil to retain smoothness, prevent ingrown hair & boost skin cell regeneration.
• Inhibit ingrown hair further by bathing with Parissa Exfoliating Gloves.
• Try Parissa Express Wax Strips for touch ups.

Quick Tips

• Previously shaved hair is strong & resistant. Wait 2 weeks or until hair is 1/4'' (1/2 cm) long before first use.
• In hot weather or when perspiring, apply talc sparingly.
• Use a damp cloth for cleaning hands during hair removal & lay a towel beneath you for tidiness.
• Always roll in direction of hair growth. Strip-off in opposite direction.
• Never roll back & forth. NEVER SQUEEZE BALL.
• The thinner you spread the product, the better the results.
• Pull strip back along itself in one quick movement. Don’t peel or pull off slowly. The faster the strip is removed the better the results.
• Turn Roll-On from time to time to avoid sugar build-up on roller.

Warnings

Common-Sense Cautions

• DO NOT OVERHEAT. Container may melt and product may cause burns.
• DO NOT apply onto skin before testing product temperature and flow.
• DO NOT use on sunburned, irritated or injured skin. Avoid varicose veins, moles and warts.
• Do not use beauty products, alcohol or astringents immediately after waxing.
• Do not use deodorants or antiperspirants for 24 hrs after underarm application.
• Do not sunbathe immediately after waxing.

Improper use such as pulling the strip up & away from the skin, not keeping skin taut during waxing, or reapplying over the same area may cause irritation, bruising or skin lifting.

Wax:

Sucrose, Fructose, Aqua, Citric Acid, Essential Oils (Lavandula Angustifolia / Melaleuca Alternifolia)

Azulene Oil:

Isopropyl Myristate (Vegetable Source), Tocopheryl Acetate (Vitamin E), Azulene, Menthol Crystals